Replace Pins In A Control Harness

Sectorseven

Active member
Joined
Mar 2, 2010
Messages
1,888
Reaction score
23
Location
Connecticut
I've got a Donkey Kong control harness that seems to be missing two pins and another is broken in half on the end that connects to the board. I think one might be the ground wire pin as I get no response from any of the four joystick switches. Start buttons and jump work though. Is there a way to replace these pins (I was going to come up with some makeshift pins but I was afraid of damaging the board) or do I just have to replace the harness?
 
Back
Top Bottom