Repair PP-7B molex?

jasonlyvers

New member
Joined
Jul 12, 2009
Messages
174
Reaction score
0
Location
Kentucky
I have a pp7b, the molex connector on the side of the big upright block has cut wires. This isn't the 9 or 10 pin, it's the white 3 pin on the side. I have the molex connector, but I'm not sure how to repair it. I'm assuming I can remove the pins from the molex connector, strip the wire, add new pins and be done - but not 100% confident. Anyone know if this will work and what size pins I need for this connector?
 

Attachments

  • IMG_0432.jpg
    IMG_0432.jpg
    87.6 KB · Views: 18
Last edited:
I have a pp7b, the molex connector on the side of the big upright block has cut wires. This isn't the 9 or 10 pin, it's the white 3 pin on the side. I have the molex connector, but I'm not sure how to repair it. I'm assuming I can remove the pins from the molex connector, strip the wire, add new pins and be done - but not 100% confident. Anyone know if this will work and what size pins I need for this connector?

Jason, If you're in the neighborhood.....swing it by the shop and I'll have you fixed in about a minute or two.

Edward
 
Back
Top Bottom