Matt Fisher
New member
I think it's about time I got this going, but I think I need some help.
My rb sorta comes up but the screen is garbage. When I power it up, the game comes on and will play, but this is what's on the screen. This is what I have done:
Had boards repaired by electronforge, so they should be good
Rebuilt arii
Replaced edge connectors
Recapped 19v2000
Tested voltages from brick, all ok
Tested voltages from arii all ok (I think)
Here's more detail: game will only fire up between about 4.3 and 4.6 v as tested on upper board. Any higher or lower and red light on start button goes solid and it will not coin up. Also I couldn't get a picture of it but graphics will occasionally expand to fill screen but still not right. I can see all of the trace lines, for example. Don't know if this is just a brightness adjustment on the monitor. This happens for only a fraction of a second.
Any help would be most appreciated!
My rb sorta comes up but the screen is garbage. When I power it up, the game comes on and will play, but this is what's on the screen. This is what I have done:
Had boards repaired by electronforge, so they should be good
Rebuilt arii
Replaced edge connectors
Recapped 19v2000
Tested voltages from brick, all ok
Tested voltages from arii all ok (I think)
Here's more detail: game will only fire up between about 4.3 and 4.6 v as tested on upper board. Any higher or lower and red light on start button goes solid and it will not coin up. Also I couldn't get a picture of it but graphics will occasionally expand to fill screen but still not right. I can see all of the trace lines, for example. Don't know if this is just a brightness adjustment on the monitor. This happens for only a fraction of a second.
Any help would be most appreciated!
