dasvis
Member
Finally getting around to working on my old Williams Aztec pin. It's my first EM & I must admit that it was a bit intimidating with all of the relays & steppers under the hood.
Watched several of Clay's videos on EM rebuilding before I started, which helped a lot, but in every case he had the stepper out of the machine & on the bench. I would have really liked to see an actual "in the machine" overhaul. It's a whole different ballgame working on it with the 50 or so wires still attached.
Anyway, so far so good. The overhaul was easier than expected & works fine now. On to the next one!
Watched several of Clay's videos on EM rebuilding before I started, which helped a lot, but in every case he had the stepper out of the machine & on the bench. I would have really liked to see an actual "in the machine" overhaul. It's a whole different ballgame working on it with the 50 or so wires still attached.
Anyway, so far so good. The overhaul was easier than expected & works fine now. On to the next one!