Rebuilt GORF Power Supply Question

Phetishboy

Well-known member
Joined
Dec 12, 2006
Messages
47,929
Reaction score
9,392
Location
Avon, Minnesota
So, since I rebuilt the Midway power board in my Gorf, do I need to meter it before I hook it up to the board stack? I had to replace the 2 100 ohm pots and I have no idea where they are set now. Can I adjust after hooking them up to a load? Or will that damage the board(s)?
 
So, since I rebuilt the Midway power board in my Gorf, do I need to meter it before I hook it up to the board stack? I had to replace the 2 100 ohm pots and I have no idea where they are set now. Can I adjust after hooking them up to a load? Or will that damage the board(s)?

I always adjust new pot to their middle point, hook everything up, and apply power......adjust as needed.

Edward
 
Back
Top Bottom