Random wire on k7600 chassis

Gump79

Active member
Joined
Oct 22, 2010
Messages
317
Reaction score
55
Location
Williamsville, New York
I just picked up a toobin' and pulled the chassis to recap and freshen up. When I went to pull the flyback I noticed a red wire tucked next to it. It connects to one end of R71. The other end looks like it was cut clean. Does anybody know where it is supposed to go?


ImageUploadedByTapatalk1354385115.261569.jpg
 
Is that wire, or could it have been, wrapped around part of the flyback a couple of turns? I have seen that in a few monitors, can't remember what the reason for it is. If it's necessary or a concern, look for a hole in the board that has the remains of the wire soldered into it, clipped off level with the board.
 
Last edited:
There is usually a small board mounted on top of the left wall above the flyback for the med-res K7000. A red wire (and a white wire) attaches to it...
 
Back
Top Bottom