VideoRob
New member
If/when you get it going I would suggest strongly doing the ground mods to avoid future or maybe current problems.
http://www.pinballninja.com/?p=1231
http://www.pinballninja.com/?p=1231
Questions about a Monte Carlo (1987)
- Thread starter anubisdeath6
- Start date
OP
OP
anubisdeath6
New member
Can someone verify that these are the correct parts that I need from Mouser to do the Dallas 1811 Modification?
80-C430C104J5R-TR
610-1N914
598-EDLNF105B5R5C
71-CCF0762R0JKE36
700-DS1811-10
I also threw in a memory cap in there to put in place of the battery.
And if anyone recommends against the Dallas chip, and thinks I'd be better off replacing each component please say so.
80-C430C104J5R-TR
610-1N914
598-EDLNF105B5R5C
71-CCF0762R0JKE36
700-DS1811-10
I also threw in a memory cap in there to put in place of the battery.
And if anyone recommends against the Dallas chip, and thinks I'd be better off replacing each component please say so.
Lindsey
Well-known member
With the DS1811 I would look at the data sheet and make sure that the part number you're ordering is the package you want (TO-92). I ordered a bunch (50) of DS1811 from mouser a while back and was sent SOT-23 parts due to an error on their site. The picture and description showed TO-92 but the part number was for an SOT-23 part. Not sure if they ever corrected their error. That's when I learned to always check the data sheet and make sure you're getting what you think you're getting.
Okay... I just checked the site and the error has been corrected. Disregard the above statement. Still a good policy in the future
Okay... I just checked the site and the error has been corrected. Disregard the above statement. Still a good policy in the future
OP
OP
anubisdeath6
New member
Haha, thanks Lindsey, but as for the other parts, are those the correct ones? I know there's supposed to be 3 parts retained, but I'm going to be replacing them with new ones. I want to make sure they're the correct parts first though.
OP
OP
anubisdeath6
New member
Disregard my last post. Ed just emailed me back from GPE. He just added some kits this morning so I'm going to just go ahead and order the kit instead of making the conversion.
