question about burger time monitor?

needhelp

Active member

Donor 3 years: 2016, 2021, 2024
Joined
Jul 8, 2009
Messages
1,018
Reaction score
7
Location
Indianapolis, Indiana
I can get ahold of a Burger Time monitor..would like to put it in my punch-out cabinet...will this work for that..will it be a plug n play. or will I have to take stuff of other monitor to do so..if so, could I get some tips on what I would need to do to get it to work...

thanks,
Need help
 
I can get ahold of a Burger Time monitor..would like to put it in my punch-out cabinet...will this work for that..will it be a plug n play. or will I have to take stuff of other monitor to do so..if so, could I get some tips on what I would need to do to get it to work...

thanks,
Need help


If the monitors are original to those machines, it will not be a direct swap. BT came with a WG G07 or a 4900 in most cases. Punchout's came with 2 Sanyo EZV's in most cases. Sanyo chassis run inverted video and have much smaller video header pins. Then there is the audio amp that comes on a Sanyo chassis but not on a standard monitor. Mike's arcade does have an inverter/conversion solution for a standard monitor that is being placed in a Nintendo set-up, but I would just hold out for a Sanyo or a Sharp myself.
 
thanks for the info..I will find out what kind of monitor it is...I was wondering if it is a burger time monitor can I use that for a cocktail multicade game...;because I have a 60 in 1 pcb board that I was wanting to put in a cocktail table...

thanks
need help
 
thanks for the info..I will find out what kind of monitor it is...I was wondering if it is a burger time monitor can I use that for a cocktail multicade game...;because I have a 60 in 1 pcb board that I was wanting to put in a cocktail table...

thanks
need help

Yep, should be no problem there.
 
Yep, should be no problem there.

phetishboy I have another question what is the difference between the Sanyo EZ and the Sanyo EZV I found a sanyo EZ one...will that be a plug in play or will I have to modify that one...and if so what do I need to do for it to work in my punchout...I am going to find out more about it later..what it came out of size, etc..thanks, for you help...


thanks again,
need help
 
Back
Top Bottom