Question about 2 in 1 switcher

arcaderookie

Member
Joined
Apr 12, 2010
Messages
521
Reaction score
1
Location
Tennessee
I bought a 2 in 1 switcher. Went to plug it in. Well it didn't switch but power came on and everything. So I looked inside the black box that is attached to the pcb. It's the phone cord, black and yellow wire. Well my question is can somebody tell me what color wires goes where? 3 of them came of and not sure where they were soldered on at. It's labeled on the pcb in the black box a's followed. gnd (which I'm sure is black, it's attached), 12v (yellow wire), com (not sure), no (not sure). The two I need is off the phone jack cord one (it's the Red and yellow wires). If anybody could help out that would be great.

Thanks in advance
 
Last edited:
This is a pic of the pcb I'm talking about.

Thanks in advance
 

Attachments

  • ImageUploadedByTapatalk1330474806.992100.jpg
    ImageUploadedByTapatalk1330474806.992100.jpg
    7.6 KB · Views: 22
Sorry I did this on my phone. And the tapatalk app reduced the pic. Didn't realize it was that small. Will post a better pic later. Sorry for whoever's looking at this thread.
 
Sorry I did this on my phone. And the tapatalk app reduced the pic. Didn't realize it was that small. Will post a better pic later. Sorry for whoever's looking at this thread.

I figured something like that but just had to give you the business.:D
 
hopefully this is a better pic.. Sorry for the small pic.

thanks for looking
 

Attachments

  • IMG_1607.jpg
    IMG_1607.jpg
    95.8 KB · Views: 10
Back
Top Bottom