Quantum owners - need a cab part measurement

DPtwiz

Well-known member
Joined
Nov 2, 2006
Messages
8,099
Reaction score
621
The piece under the control panel, that the control panel bolts on. I sketched it out on paint real quick. Bolt hole measurements from the left side of the cab to hole center is what i need on those, and the other ones marked. Thanks in advance for any help! It's the last piece i need to program. thanks!

quantum.jpg
 
anyone? you don't have to take the control panel off, just unlatch it!
 
bump.. really need these dimensions. I didn't want to announce Quantum cabs available till i have a finished one with pictures, but i do have em. Except this one part..
 
Wiz:

I just got moving and haven't had coffee yet. All my measurements were taken from the left side of the board so you will have to do the math. I refuse to add or subtract fractions without coffee.

Width of board 3 1/2 "
first hole 1 1/2" from LH edge of board
2nd hole 11 7/8 " from LH edge of board
3rd hole 22 1/4" from LH edge of board
First notch is 9" from LH side
Notches are 1/2" deep with rounded corners
Notches are 1 1/4" wide
2nd notch is 13 1/2 " from LH side of board
Board total width is 23 3/4"

You don't show the small supports in the top corners of the board

They are cut from 3/4" stock and are 2 1/8 " long and tuck into the very top corners of the board and support it to the cabinet. You may have this already.


pi= 3.14159265358979323846264338327950288419716939937

off to drink coffee now
 
thank you komodo! Yep, the blocks aren't there cause it's just sitting there.. i was using it for side block alignment :D
 
Back
Top Bottom