Quantum CP re-run?

What would the cost be? I'm interested but have not been around much and don't know the details of a prior run.

On the last run, they were $65 each which was a die punched powder coated panel with the hinge and lockdown tabs. The display shield was $22 powder coated.
 
Bump! Almost halfway there....need about 12-15 to re-run these.
 
Last edited:
If 12 is the magic number... get 10 commitments and I'll buy 2 extra sets (for a total of 3 sets) to make this happen. I don't need them but I can resell them (at cost) as other people pop up looking for them. I just want to know this'll happen.
 
If 12 is the magic number... get 10 commitments and I'll buy 2 extra sets (for a total of 3 sets) to make this happen. I don't need them but I can resell them (at cost) as other people pop up looking for them. I just want to know this'll happen.

Sounds good. I appreciate you stepping up to support the project. Once the interest list hits 12, I'll start accepting prepayments and get this going. i'm sure it will hit that especially with the PCB coming out.

-Troy
 
I am unfamiliar with the Quantum cabinet. What is the display shield again? Where does it sit? Is this piece only on Quantum and not any of the others that share a similar cabinet like SD and Grav?
 
I am unfamiliar with the Quantum cabinet. What is the display shield again? Where does it sit? Is this piece only on Quantum and not any of the others that share a similar cabinet like SD and Grav?

Yes, I belive it is not on the other cabinets. Its a metal bracket the slides into 2 slots which are on the wood support pieces for the CP. It supports the glass or another way to descibe it, the glass sits in the channel of the display shield (the manual calls it a display shield)
 
Back
Top Bottom