hotrod797
New member
I am looking for a wiring harness for a QIX II machine, it has the r-15 harness that runs from the coin door board to the front of the machine, but someone cut the wires off the coin mech's and unplugged the harness and I would rather not cut or hack this stock end off if I don't have to... Here is what I have found it to have:
CONNECTOR J15
1 Adv Test (Yel) [Coin Door PCB J15-1]
2 Sub Test (Grn) [Coin Door PCB J15-2]
3 Slew Up (Blu) [Coin Door PCB J15-3]
4 Slew Dn (Vio) [Coin Door PCB J15-4]
5 Left Coin SW (Brn) [Coin Door PCB J15-5]
6 Right Coin SW (Red) [Coin Door PCB J15-6]
7 NC
8 Tilt (Org) [Coin Door PCB J15-8]
9 NC
10 GND (Blk) [Coin Door PCB J15-10]
11 Coin Lock? Out (Wht) [Coin Door PCB J15-11]
12 Coin Lock Out (Wht/Blk) [Coin Door PCB J15-12]
13 Coin Counter (Blk/Brn) [Coin Door PCB J15-13]
14 +12 (Gry) [Coin Door PCB J15-14]
(What is slew up/down??)
PS: sorry if I used wrong terms to describe parts, I am brand new to arcades, this is my first one and I honestly have no clue what I'm doing, so I'm just learning as I go....
As of right now the machine is in non working order, I hear the screen come on but that's it... I think it may need a new power supply because this one is in super rough shape...
CONNECTOR J15
1 Adv Test (Yel) [Coin Door PCB J15-1]
2 Sub Test (Grn) [Coin Door PCB J15-2]
3 Slew Up (Blu) [Coin Door PCB J15-3]
4 Slew Dn (Vio) [Coin Door PCB J15-4]
5 Left Coin SW (Brn) [Coin Door PCB J15-5]
6 Right Coin SW (Red) [Coin Door PCB J15-6]
7 NC
8 Tilt (Org) [Coin Door PCB J15-8]
9 NC
10 GND (Blk) [Coin Door PCB J15-10]
11 Coin Lock? Out (Wht) [Coin Door PCB J15-11]
12 Coin Lock Out (Wht/Blk) [Coin Door PCB J15-12]
13 Coin Counter (Blk/Brn) [Coin Door PCB J15-13]
14 +12 (Gry) [Coin Door PCB J15-14]
(What is slew up/down??)
PS: sorry if I used wrong terms to describe parts, I am brand new to arcades, this is my first one and I honestly have no clue what I'm doing, so I'm just learning as I go....
As of right now the machine is in non working order, I hear the screen come on but that's it... I think it may need a new power supply because this one is in super rough shape...