Here is a picture of my powerbrick on the complete qbert, fully working.
The cab that I have restored which was a mania challenge, utilized this powerbrick, but hacked the ac power to a switcher.
My question is this:
Is that just an ac power distribution (the 16 pin molex or however many it is)?
If so, it should all be the same amount of power from each pin right? I don't have this part hooked up right now. Though I did get the connector which I could hack a bit into my new wiring (marquee, on/off, etc.)
With that being said, I should be able to run any wire to any spot I want huh? From the molex connector?
anyone following this?
The cab that I have restored which was a mania challenge, utilized this powerbrick, but hacked the ac power to a switcher.
My question is this:
Is that just an ac power distribution (the 16 pin molex or however many it is)?
If so, it should all be the same amount of power from each pin right? I don't have this part hooked up right now. Though I did get the connector which I could hack a bit into my new wiring (marquee, on/off, etc.)
With that being said, I should be able to run any wire to any spot I want huh? From the molex connector?
anyone following this?
Last edited:
