Punch Out PCB Graphics Glitches, possible sound as well

DreamTR

Well-known member
Joined
Jul 12, 2007
Messages
4,824
Reaction score
725
Location
SMYRNA, Tennessee
Punch Out PCB Graphics Glitches, possible sound as well

Ayone able to fix one of these at a decent price? The board does work, but has graphic glitches, it may not have sound, and I can't coin up, but I didn't install the right control panel yet...
 
thoughts

Have you tried cleaning the board with electronics cleaner and reseating all the removable chips? Also there is a dip switch setting for the boot check. Turn that on and see if it reports anything.

I had a few glitches on a PO PCB and it was just some chips that needed to be reseated. 9 out of 10 times it's from the PCB being moved around and flexing, causing the chips to lose a good connection.
 
Mine had a similar issue.

ONE of my color proms were bad and needed replacing. That solved the mis-color issue. If you can NOT coin up try this > make sure there is a GOOD bulb behind the 25c slot. IF the bulb lights up then you have a good board to coin connection. If the bulb is NOT lighting up a connection issue exists between the board and coin up slot thus it is NOT recognizing a coin drop.

As for the graphic GLITCHES > I also battled that one. The filter card that enters the cage that holds the PCB was my issue. After a complete cleaning and re-seating of all chips on the PCB my glitches went away!
 
Back
Top Bottom