pulled my wg6100 and there is big gap between yoke and tube!

smpoponi

Active member
Joined
May 23, 2006
Messages
1,295
Reaction score
2
Location
audubon, New Jersey
pulled my wg6100 and there is big gap between yoke and tube!

Like a big one, maybe 2 inches.

So I am about to do a capkit on this chasis, I just get a dot in the middle of the screen, its in a Space Duel that played blind when I bought it.


I get it on my bench and immediately I see the rubber shims but they are not making contact with yoke but are stuck to the tube. Gotta be honest I am not even sure what they do. Obviously they adjust something, I just dont know what.

Do I just loosen that clamp and move em back together?
 
Yeah,just slide it forward until it touches the wedges.You may have to adjust it later to center the picture though.Hopefully the rings are still in the right position.
 
smpoponi lives!

Yes, as vctrcollectr alludes to, the rubber wedges keep the yoke properly positioned on the monitor neck. If the yoke is tilted left/right/up/down compared to when it was working properly, you will likely have convergence issues along the outer edges and corners.
 
Scott, I DO LIVES!

Finally got a new house over the summer with an awesome finished basement. Got about 20 games down here. So pumped on life!
 
Back
Top Bottom