Hi,
I got from eBay a PS to JAMMA adapter, pictured below. I connected my PS2 slim to it and I have video and audio out but no controller signals. I plugged the oscilloscope to try to see if I got anything on the controller output but I can't get anything looking like a digital protocol on it nor any change when I press any buttons/joystick.
Has anyone seen/can advise about this?
The PCB is connected through a ribbon band to a battery of 20 dip switches, which I don't have the slightest idea what are they suppose to do. I switched a lot of combination of them on and off and power the board down and up but it doesn't seems to change anything.
My thinking is that either
- there is something wrong with the PCB
- or it was meant to work only for PS1 consoles which I have none around
- or some dip switch combination may change the supported console
Any ideas please?
I got from eBay a PS to JAMMA adapter, pictured below. I connected my PS2 slim to it and I have video and audio out but no controller signals. I plugged the oscilloscope to try to see if I got anything on the controller output but I can't get anything looking like a digital protocol on it nor any change when I press any buttons/joystick.
Has anyone seen/can advise about this?
The PCB is connected through a ribbon band to a battery of 20 dip switches, which I don't have the slightest idea what are they suppose to do. I switched a lot of combination of them on and off and power the board down and up but it doesn't seems to change anything.
My thinking is that either
- there is something wrong with the PCB
- or it was meant to work only for PS1 consoles which I have none around
- or some dip switch combination may change the supported console
Any ideas please?
Attachments
Last edited: