Pole Position 2 Parts for sale

rmackie6661

Active member
Joined
Oct 17, 2006
Messages
1,422
Reaction score
7
Location
Cottage Grove, Minnesota
Rating - 100%
22   0   0
Hey everyone, I just parted out another damn Pole Position Cab (That makes 9 in the last three years) it had the Pole 2 Kit installed in it. The vendor I got it from stated that it was working then just quite on him. I took a look inside and yup the Main PCB's had some burn edges on them. Not bad but enough.

I'm sure with a little resoldering and wire tinkering you should have a nice working board set. the Main CPU board was a little worse than the video Board set. For giggles I Plugged it in and did get a picture on it with good colors and could tell it was the track but that's it.

SO Make me an offer for anything. The Bezel is really nice with no chips or flakes and so is the Marquee.

I also have the full wiring harness and power block as well as the two working ARII boards.

PCB is as stated above and complete with no acid burn by the batteries.

Just PM me the offers shipping zip is 55016
 
Back
Top Bottom