Please Help Identify Monitors/Chassis

acblunden2

Active member
Joined
Mar 26, 2016
Messages
1,028
Reaction score
19
Location
Modesto, California
Here is the first one. Nested inside a Dynamo HS-9: https://goo.gl/photos/vRnGMk87ZptKc9s46

I don't have a good pic of this one. Would require a major moving effort to get a good picture. But it is a monitor inside of a Die Hard Arcade cab: https://goo.gl/photos/meC2EPvph7BQxyHP9

Not the greatest photo, but let me know what you think. Let me know if I need a better photo: https://goo.gl/photos/fiMbjSzQA4JXg5Tx6

And this guy. From says it is an Electrohome of some sort. I should have taken a photo with the dead rat squeezed inside there, but saved you guys from the gore: https://goo.gl/photos/jZ93Ln7G9NmMuGgr9

I also have a Tekken 5 cab. Monitor is a flat screen hi-res monitor. Anyone know what monitor is in that one? Want to buy a cap kit for it now. I won't be able to take better photos until I get clear skies. I have move stuff out of garage below open air to do so. Thanks for the help!

1114301648.jpg
 
Last edited:
k7400 is the first one.

the electrohome should be a GO7 and it should say on the sticker to the left that is cutoff in the picture. -CBO
 
Last edited:
k7400 is the first one.

the electrohome should be a GO7 and it should say on the sticker to the left that is cutoff in the picture. -CBO

thanks Peter. From what I have read, the Die Hard Arcade cabs (the 2nd one from above) had WG U2000's in them. Might have to take this one out to be sure. Question about these monitors since they don't run with ISO's. Is it smart to add an ISO for such monitors if at all even possible?
 
thanks Peter. From what I have read, the Die Hard Arcade cabs (the 2nd one from above) had WG U2000's in them. Might have to take this one out to be sure. Question about these monitors since they don't run with ISO's. Is it smart to add an ISO for such monitors if at all even possible?

most of those WG have a board number and/or a white sticker on the left side that has a model number you can decode so i would check that first before going to the trouble of removing the chassis.
 
Back
Top Bottom