Kid Raster
Well-known member
Hey everyone,
Picked up a long coveted PC-10 this last week.
Machine turns on and seems to operate ok, except the bottom screen is 'smeared'.
Like it does not sync correctly or something. But- here's the thing-
If I disconnect the video signal molex and reconnect it while the machine is on and a game is selected, the monitor comes up just fine and it is playable~ but as soon as the machine switches to another game, or the machine is switched off and on again it goes back to a garbled mess. If you disconnect and reconnect the molex again (while on) the screen is fine. So when you power it on and when in attract mode it switches to another game on the board, the lower screen (game screen) goes all wonky.
Any ideas? I'd love to bring this one in the house!
Thanks everyone!!!
Justin
Picked up a long coveted PC-10 this last week.
Machine turns on and seems to operate ok, except the bottom screen is 'smeared'.
Like it does not sync correctly or something. But- here's the thing-
If I disconnect the video signal molex and reconnect it while the machine is on and a game is selected, the monitor comes up just fine and it is playable~ but as soon as the machine switches to another game, or the machine is switched off and on again it goes back to a garbled mess. If you disconnect and reconnect the molex again (while on) the screen is fine. So when you power it on and when in attract mode it switches to another game on the board, the lower screen (game screen) goes all wonky.
Any ideas? I'd love to bring this one in the house!
Thanks everyone!!!
Justin
