playchoice 10 question

fast-ed

New member
Joined
Jan 8, 2012
Messages
2,500
Reaction score
31
Location
potosi, Missouri
i know mikes arcade sell an adapter board so you can install a non nintendo monitor in a dk. my question is will it work in a pc10. the monitor cables are different. pc10 has a cable that is square unlike dk. do the make an adapter for this? anybody? thank you ed
 
I think (not 100% sure thou) the PC10 doesnt use any form of invertor board, as the countertop had a regular WG monitor in it, that went to the filter board as per the upright so I dont see why you couldnt just hook up a regular monitor, that would be my take, probably wrong thou ???
 
Both the PC10 Single and Dual used inverted video. SOME EZ20's had a the inverter board on it that would let you use the Sanyo monitor on a standard game. There are other chassis like a K7000 which was stock in a single monitor and used inverted video.. Either way it is all inverted. I don't know any specifics on the countertop, but I suspect the same thing.

Regarding the connector. I just found the pinouts and made made my own adapter by just slicing off one end of the Sanyo cable.
 
I think (not 100% sure thou) the PC10 doesnt use any form of invertor board, as the countertop had a regular WG monitor in it, that went to the filter board as per the upright so I dont see why you couldnt just hook up a regular monitor, that would be my take, probably wrong thou ???

Yes, it needs a video inverter. In the video below, you can see at 1:25 the inverter board used inconjunction with my G07-CBO.



In addition, there is a modifIcation to switch the K7000 from normal sync signal to inverted signal.

http://forums.arcade-museum.com/showthread.php?t=149066
 
Back
Top Bottom