Pinbot wiring Help

Joined
Mar 6, 2011
Messages
246
Reaction score
0
Location
muscatine, Iowa
I have pinbot that I recently picked up and everything seems to be working well except for switch 11,12, and 13. I have found that the left outlane and left return lane switches are not working. There are two loose wires that look as though they both run to those particular switches. it is a green wire with a red stripe. I was wondering if anyone would be kind enough to take a detailed picture of the underside of the playfield, so I might be able to figure this out.

any help on this would be greatly appreciated. I will post pictures of it later tonight if anyone thinks it will help
 
Sounds like the wires just came loose, no biggie. I'll try and get you a pic in a few hours when I get home. Should just be a matter of which one goes to what switch and resoldering hopefully. :)
 
Thanks a ton!! that was exactly what I was looking for. Now those 2 switches are in working order. The only problem I'm having now is with switch 28. It says left visor on the display, but I will mess with that tomorrow. Thanks again. I wanted to get everything in working order before I even attempt a play-field swap.
 
Last edited:
Thanks a ton!! that was exactly what I was looking for. Now those 2 switches are in working order. The only problem I'm having now is with switch 28. It says left visor on the display, but I will mess with that tomorrow. Thanks again. I wanted to get everything in working order before I even attempt a play-field swap.


I'm the same way. Did the same thing with Shuttle. I rebuilt everything on the old playfield knowing I was going to do a PF swap anyways. :)

Left Visor is probably the eye lock hole underneath.
 
Back
Top Bottom