My Pinbot is up and running and it works great. Only a couple little issues left to figure out so I can have it running perfectly. One issue I am having is that since I rebuilt the flippers it seems that sometimes when I shoot the ball up to the solar value ramp it goes so fast that it launches up on top of the plastic in the back left and rolls down the left side of the cab until it gets stuck behind the flash lamp dome about halfway down the left side (see arrow in pic). For the time being I constructed a little wall/guide basically where there is a circled area in the pic and it helps to keep the ball from flying up above the ramp. I was thinking of constructing some sort of wire guide but would hate to put the effort into something like that if there is an easier fix for this issue.