pinball switch question?

phatchit

Member
Joined
Feb 17, 2010
Messages
579
Reaction score
2
Location
Davenport, Florida
I posted this in the general section so i thought i should post here to.I just picked up a REd and teds roadshow and it keeps telling me to check switches 47 and 53. I followed that to a board with an LED on it and a adjustable pot.I adjusted it as I read in a post and still nothing .Could that baord be bad? The led lights up .Does anyone have any sugesstions? IT is the switches that control the points for the bulldozer and the kick out ramp on the left side? What am I missing ? THanks guys adn sorry its not posted in the pinball section.PEACE!!
 
To adjust the eddy sensor, turn the potentiometer until the LED goes on, then back off just until it goes out.

Lower playfield, go into switch edge test, roll a steel ball over the eddy sensor area, it should register on the DMD as a switch closure.
LTG :)
 
Back
Top Bottom