I have a 25" Pentranic monitor with CH288 chassis mounted vertically in my cabinet.
The picture is too wide by about 5-10% -- stuff's getting clipped. (Because it's mounted vertically the top and bottom are what's being clipped).
Can anyone suggest why and what I can do to reduce the picture size? I have the h width pot set to the minimum and am seeing the 5-10% clipping.
Is this a B+ issue? Horiz width coil? Any suggestions?
I did find this thread:
http://forum.arcadecontrols.com/index.php?topic=93335.0
But I have no idea of what he did to adjust the width coil. As he said, it doesn't seem to move on my chassis. There doesn't seem to be anything inside it TO move.
The picture is too wide by about 5-10% -- stuff's getting clipped. (Because it's mounted vertically the top and bottom are what's being clipped).
Can anyone suggest why and what I can do to reduce the picture size? I have the h width pot set to the minimum and am seeing the 5-10% clipping.
Is this a B+ issue? Horiz width coil? Any suggestions?
I did find this thread:
http://forum.arcadecontrols.com/index.php?topic=93335.0
But I have no idea of what he did to adjust the width coil. As he said, it doesn't seem to move on my chassis. There doesn't seem to be anything inside it TO move.
