Pc-10 & po / spo

hindered

Well-known member

Donor 2015
Joined
Jun 4, 2009
Messages
1,796
Reaction score
32
Location
Kalamazoo, Michigan
I might be about to pick up a two monitor PC-10. If I were, could this be converted to Punch Out or Super Punch Out? Would I need to change the wiring around for either of them? What would be involved in the conversion (ignoring repainting, rebuilding a control panel, side art, etc) from a technical standpoint? Could I just remove the PC-10 main PCB and put in the PO/SPO PCB and call it good?
 
I know notrecaine has done this conversion back and forth between PO and PC-10 so you should PM him. To the best of my knowledge the only differences are:
1)PCB (obviously)
2)Control Panel
3)Marquee
4)Side Art

I believe the PC-10 wiring will work for PO... it's just a matter of the correct gameboard and the control panel.
 
CP wiring is different at the CP only. You can plug and play with the molex connector to the control panel. PC10 also utilizes an extra harness. I swap between PC10 and Playchoice in one cabinet with no problem.
 
Back
Top Bottom