parts needed?

paulmg01

Member
Joined
Feb 5, 2010
Messages
147
Reaction score
0
Location
Waterford, New York
last month I bought a commando cab on craigslist for $100. My intention was to mame it. After the kid delivered it I realized it was not the same as the one picture on cl. It is actually an original pacman cab someone coverted to commando. I stripped it and sold off the commando stuff for 55 bucks. My new plan is to restore it to pacman on the outside and put a 60-1pcb inside.

I plan on using the hacked up commando control panel to make a "multicade-esq" control panel. I figure I can find another pacman cp to restore that I could just switch out by making a pin connector.

My question is, beside the 60-1 pcb what will I need? I do not know much about jamma wiring. I know I need a new power supply and harness but which ones? What buttons will I need and how many? trackball?

Any help would be great
thanks
 
General repair forum might be a better place to post this thread.

1. Jamma Harness $15
2. Switching power supply with +5v, +12v, etc $15
3. Player 1, player 2 buttons should be there already
4. 2 action buttons (3 if you have the space) you'll have em already with the joystick
5. Trackball is a good way to go, but not necessary ~$60
 
Last edited:
Back
Top Bottom