pinbotler
Member
Message says it all. Picked up a cocktail with a 2 board PCB pac man clone labeled Gobbler. Power supply is gone. Have the harness and all is disconnected tho the molex connectors still there. 44 pin pcb edge connector.
So if anyone can confirm for me:
The voltages required to run this (see 7, 5 and 12 depending on pinouts I found)
The pinout for this boards pcb. Have read there are several 2-board pac clones with the same hardware. Read another link about gobbler and chomper having same basic pcb. Anyone can help me please do want to see what kind of PS I am in need of. As a bonus looks like the 13 inch monitor is still good.
So if anyone can confirm for me:
The voltages required to run this (see 7, 5 and 12 depending on pinouts I found)
The pinout for this boards pcb. Have read there are several 2-board pac clones with the same hardware. Read another link about gobbler and chomper having same basic pcb. Anyone can help me please do want to see what kind of PS I am in need of. As a bonus looks like the 13 inch monitor is still good.