So here's my next monitor F-up....
Got a Nintendo dual system with Sharp XM-200's. #1 monitor works but has bad fold over. Monitor 2 is dead. Ordered cap kits
Capped monitor 1. Works great
Capped monitor 2. and I made a boo boo....forgot to connect dag wire. Fired it and all kinds of clicking/buzzing noise from the flyback. Saw smoke and shut it down, then I realized I forgot about the dag wire.
Connected dag wire and tried again just for shits and giggles (I knew I shoudn't have done it again). Got a pic (small and wavy) then the noise went away...The monitor shows a small green dot and I shut it down. Small green dot stays on monitor with no power for 5 minutes.
I thought I read a while back that new flybacks for this monitor do not exist? True?
By firing it again, I'm assuming I blew something else...ideas??
By not connecting the dag wire, did I blow the flyback? I have this feeling it was already gone.
Got a Nintendo dual system with Sharp XM-200's. #1 monitor works but has bad fold over. Monitor 2 is dead. Ordered cap kits
Capped monitor 1. Works great
Capped monitor 2. and I made a boo boo....forgot to connect dag wire. Fired it and all kinds of clicking/buzzing noise from the flyback. Saw smoke and shut it down, then I realized I forgot about the dag wire.
Connected dag wire and tried again just for shits and giggles (I knew I shoudn't have done it again). Got a pic (small and wavy) then the noise went away...The monitor shows a small green dot and I shut it down. Small green dot stays on monitor with no power for 5 minutes.
I thought I read a while back that new flybacks for this monitor do not exist? True?
By firing it again, I'm assuming I blew something else...ideas??
By not connecting the dag wire, did I blow the flyback? I have this feeling it was already gone.