Omega Race ORDS installation...

Jeff F

Well-known member

Donor 12 years: 2011-2022
Joined
Feb 22, 2009
Messages
5,631
Reaction score
216
Location
Johnson City, New York
Has anyone ever installed one on a cabaret? If so, where does the 2x3 Molex go? I'm about to splice into the +5v line to get power to the ORDS board because for the life of me, I can't find the 2x3 Molex referenced in the instructions?

Just curious if anyone else has run into this?

Thanks,
Jeff
 
Figured it out. There is no 2x3 Molex in my cabaret as described in the instruction. I just took the +5v line from the A/G board that the new spinner bypasses anyway. It was located close enough that I didn't have to do any splicing, just had to remove the ground and +5v from the A/G connector and put them in a 2 space connector for the ORDS module.

Man... ORDS kicks butt!!! :D Even my son noticed how much smoother the control is with ORDS.

Awesome! :beerchug:
 
Someone PM'd asking what ORDS is so I figure I'll do a little advertising for it. :D

It's a spinner replacement and it is way, WAY more accurate than the original analog spinner. Here's the website...
http://www.biltronix.com/ords.html

And here are a couple pictures of the spinner replacement...
attachment.php


attachment.php


Best ~$50 I've ever spent to improve gameplay.
 

Attachments

  • ORDS_PCB_012_200x150.jpg
    ORDS_PCB_012_200x150.jpg
    9.2 KB · Views: 43
  • ORDS_PCB_013_200x150.jpg
    ORDS_PCB_013_200x150.jpg
    9.2 KB · Views: 42
WOW!! I never heard of that either! I need to get one of those for my Omega Race cockpit restoration! Thanks for sharing. ;)
 
Back
Top Bottom