ok, tempest monitor is working but a fuse was blown, should I be worried....

tron guy

Super Moderator
Staff member

Donor 12 years: 2011, 2015-2025
Joined
Jun 26, 2007
Messages
23,145
Reaction score
2,593
Location
Eureka, California
ok, tempest monitor is working but a fuse was blown, should I be worried....

or just replace the fuse and forget about it if it doesn't blow again.
r102 it's the front right one. 5amp 250 . (can't remeber if it's r102 or not, but it's the front right one if you had the chassis out.)

Anyway I rebuilt the power board since I had the parts.
The voltages that I measure on the board are good. +5=+5 etc, across the board.

I am just going to drop a lv6100 and be done with it I think.

unless someone has other suggestions.
I guess what I am asking, is, if it blew the fuse once, but not since, should I be concerned? This guy hauled his game over to my house, and I would hate to go through this again.
 
Last edited:
don't know if Mark has any lv6100's

if he doesn't, you could just go with a lv2000

I got one, I try to always keep one on hand. his is easier to install (going off of memory)
I need to see if I have some instructions still. though I seem to remember there wasn't a lot to it.
 
Back
Top Bottom