Well, after spending a lot of the day looking and reading up, I have a strong suspicion I know what everyone's gonna say, but I figured I'd post and confirm my fears.
Have a Neotec NT-2701, Li-Chin model, with a Zenith tube, and it has several issues...
(1) Dim - even with brightness full up, it's on the dim side.
(2) Focus - The center is focused fine, but the farther you get out to the edges, the more unfocused it gets. It's not color-based, as individual cross-hatch patterns of the colors all look the same.
(3) Gone Fuzzy - It's only happened once, but like mentioned in another thread - the one time it happened, it was on for about 15-30 minutes, and went absolutely completely out of focus. Turned it off, and the next day was back to normal.
I can do PCB repair, but not sure if this is worth my time. Thoughts?
Have a Neotec NT-2701, Li-Chin model, with a Zenith tube, and it has several issues...
(1) Dim - even with brightness full up, it's on the dim side.
(2) Focus - The center is focused fine, but the farther you get out to the edges, the more unfocused it gets. It's not color-based, as individual cross-hatch patterns of the colors all look the same.
(3) Gone Fuzzy - It's only happened once, but like mentioned in another thread - the one time it happened, it was on for about 15-30 minutes, and went absolutely completely out of focus. Turned it off, and the next day was back to normal.
I can do PCB repair, but not sure if this is worth my time. Thoughts?
