No Power on Baby Pac

troxel

Well-known member

Donor 7 years: 2015-2021
Joined
Mar 19, 2006
Messages
2,084
Reaction score
104
Location
Lincoln, Nebraska
Working on a my Baby Pac lately, and finally had the chance to plug it in. I have rewired some of it including the DPST switch and the playfield plug. When I plugged in the game, I have no power to it. I checked all fuses (6 on the PCB and one by the service outlet) checked the interlock switch. Power cord looks new on it, and looks to be wires correctly. I pulled out the power supply board and checked bridges, diodes, and resistors. All looked good.

Where should I check for voltages? I see test points on the board, but not sure what they should be. Just trying to figure out where I am losing power at.

Any ideas would be appreciated.

Thanks,
Theron
 
Check for power at the transformer first, if there is no power there then there is likely no power to the cab. Then you can check for power at the fuses on the power supply.
 
Thanks for the input. The interlock switch wasn't wired correctly. Switched two wires, and the game powered up. Need to look at it closer, but the video game up and the solenoid kicked. Pretty excited to get this close, because it was a wiring mess a couple of days ago.

Theron
 
Back
Top Bottom