FS Parts: Nintendo "Super" harness for DK, DKjr, DK3, Mario Bros, Popeye

Dokert

Well-known member
Joined
Jun 3, 2007
Messages
12,751
Reaction score
141
Location
Arlington, Washington
Rating - 100%
85   0   0
Nintendo "Super" harness for DK, DKjr, DK3, Mario Bros, Popeye

I have recently had a lot of contact asking for the Nintendo "Super" harness, and it looks like we may have enough interest to do another run. This is one of the most expensive harnesses for us to make, and a run usually costs in the neighborhood of $1500 up front.

I need to see a show of hands to even consider making a run. The magic number for consideration is 20, for serious consideration is 30.

Please keep in mind that I have over 450 pm's in my box, and it will be hard for me to go through and search out the people who have said they are interested in one of these harnesses. My email is pretty full too. Please post your interest here, so that we can find it a little bit easier.

The price is going to be $80 shipped (lower 48)

Outside the United States is on a case by case basis due to shipping costs. Usually the additional shipping cost for outside the US is $10-$15.

What do you get for that kind of money?

1. Main harness
2. Control Panel harness
3. Rainbow cable (all boardsets require it)

We have had too many people come back to us needing a control panel harness after installing the new main harness. We have determined that this is the best solution to fix this problem.

These harnesses only support 2 - board sets, and we do not offer a solution for the 4 - board set.

Dok
.
 
First one on!!!

I'd be in for 3. I'd also be in for 2 extra control panel harnesses and rainbow cables if available.
 
Last edited:
Sounds good.

I can't pass up.
I will take one.
So it is one harness that works on all those games mentioned?
 
I dont know about this harness....this Chuck guy said that it is crap :p....

I could probably pickup one if they were available...one of those things that would be good to have on hand for the future :)
 
Do these harnesses work with some sort of switch to switch between the boards or is it a manual swap of the connector to the various PCBs?
 
Back
Top Bottom