Nintendo sanyo dies after a few seconds after turning on

theminer49er

Permanently Banned. Thief. More than $10,000 USD s
Joined
Sep 23, 2011
Messages
172
Reaction score
1
Location
hagerstown, Maryland
Nintendo sanyo dies after a few seconds after turning on

Howdy yall,
I am trying to get my dual PC-10 done and in the house, but the monitor will not cooperate. I recapped it and replace the 3 resistors in the kit. I also put a new flyback on it. It worked great the day I installed it and the next day when it was on for like 6 hours. But yesterday this started happening:
I turn it on it gets high voltage the tube warms up(still black screen) then it just dies.
It doesn't make a loud sound... just stops working. I am going to take it back out and inspect it, but I thought I would throw this line out and see if I get any helpful bites...just in case I can't figure it out. I am new to sanyos. I work on Go7s and WGs all day long, but I have only capped about 6 nintendos and replaced 3 flybacks, but they all work great!!! I am not a noob ...I just never ran into this.
Thanks
Chase
 
yup if your B+ it is two high it will work for a few then shut down.

it should be 108vdc.

if you have that POS metal pot on the chassis i suggest replacing it.

Peace
Buffett
 
totally what is was...that pot is crap...ordered a bunch of replacements from twisty wrist
 
Last edited:
twisty wrist

thats where i get mine.. they work flawlessly.. hmm flawlessly , is that a word?
 
Back
Top Bottom