Nintendo Red Tent monitor -pcb extra?

railwarrior

Active member
Joined
May 29, 2006
Messages
1,716
Reaction score
16
Location
West, Texas
Trying to get my red tent up and going. One monitor was totally white...so I pulled it out when I noticed a difference between the two.
The monitor giving me trouble has an extra board on it.
IMG_0167.jpg


There is a connector soldered to positive side of C306 on the bottom of the chassis that wasn't hooked up.
IMG_0168.jpg

I'm assuming it plugs into the board here: (blurry picture with white square)
IMG_0169a.jpg


Should I bypass this board for now and hook the monitor up same as the other?
 
That's an inverter board. You don't need it for VS. games. I would just eliminate it. That unused connector is for powering the inverter board. I can't tell what is in the blurry picture, but if it's not the inverter board....do not plug that connector into it.

Edward
 
The blurry one is the underneath of the monitor chassis where 1 wire is soldered with a connector that was hanging loose.
I'll remove the inverter board and see what happens...

Thanks for your help!
 
Back
Top Bottom