timberterror
Well-known member
I recently aquired a Playchoice cab. Since the monitors are old I decided to recap them. They are both Sanyo 20Z2AW's. Th upper monitor looked ok before the cap kit and looks and work fine now. The lower monitor on the other hand was dim before, but seemed to work ok.
After the cap kit it was still dim so I checked the B+ and it was 20 volts low. I got it up to a hair over 108 and it looked much better- then all of a sudden the "clicking" started and the monitor rolls. I am 99% sure the fly is going out eventhough I can't see anything.
With fly's for these being very difficult to find, could I use the tube with a 20EZ chassis. I looked at my DK and the tube part numbers match. If so it would be easier to find one of those. What do ya'll think? - Barry
After the cap kit it was still dim so I checked the B+ and it was 20 volts low. I got it up to a hair over 108 and it looked much better- then all of a sudden the "clicking" started and the monitor rolls. I am 99% sure the fly is going out eventhough I can't see anything.
With fly's for these being very difficult to find, could I use the tube with a 20EZ chassis. I looked at my DK and the tube part numbers match. If so it would be easier to find one of those. What do ya'll think? - Barry