Nintendo (DK Series) Control Panel Harness

I'm in for a couple also.

I would also need something more extra because I'm restoring a Mario WB and I got a Popeye harness not knowing that there was no 2P hooked up for him. I also need my Mario CP harness to have 4 way wiring for P1 so that I can swap in a Popeye board.

I would need the length of wire to run from the CP molex down to the Board connector. I can give you the exact length and can go over this.

I just don't know where to get the male connector for this type nor want to go through all of the trouble. I'd pay to have this done.
 
sweet! I'm still in for one...just installed a DK cp on my vs cab (sans the harness).
 
We are taking the official List for those who are interested in the original DK series cp harness only. If we can find a suitable replacement for the Molex version we will post about it. These should be ready to ship, hopefully by the end of October or shortly after.
 
Here are the pics of the Prototype of the Nintendo (DK Series) Control Panel Harness. The wire colors will be corrected at production time to better match the scat.

We are taking a List of who is interested in these. The cost is $15 shipped.

View attachment 15178View attachment 15179View attachment 15180View attachment 15181View attachment 15182

The first 10 are done and ready to ship. Timberterror will be the point of contact on these. He will be contacting people via pm, before he puts them up for sale in the for sale section.
 
6 of the first 10 are sold and shipping. Thanks to all those that ordered. Just waiting to hear back from the others interested before I list them in the for sale section. I have better pics of the harnesses in my albums. Thanks again, Barry
 
Sorry, was a bit late on the reply to the pm, and payment sent!

Looking forward to the new harness! Thanks for working on these guys!
 
Back
Top Bottom