Nintendo Coin Mech Face Plate Bolts - Need Picture/Description

wxforecaster

Member
Joined
Sep 17, 2010
Messages
646
Reaction score
12
Location
Moon Township, Pennsylvania
Nintendo Coin Mech Face Plate Bolts - Need Picture/Description

During my DK Jr restore I noticed that neither of the coin mech face plates were attached to the door itself and merely held there by gravity from the coin mechs themselves inside the door.

The faceplates I have are the standard 740s (round coin return button in the center) with circular holes in each of the 4 corners (as opposed to the square holes found on the 730-As and most carriage bolts).

Can someone provide a description (and possibly) a picture of what the bolts and nuts are? My guess is a 4mm (assuming Nintendo used metric on everything), but not sure what type of bolt is used.

Thanks in advance,
Evan
 
During my DK Jr restore I noticed that neither of the coin mech face plates were attached to the door itself and merely held there by gravity from the coin mechs themselves inside the door.

The faceplates I have are the standard 740s (round coin return button in the center) with circular holes in each of the 4 corners (as opposed to the square holes found on the 730-As and most carriage bolts).

Can someone provide a description (and possibly) a picture of what the bolts and nuts are? My guess is a 4mm (assuming Nintendo used metric on everything), but not sure what type of bolt is used.

Thanks in advance,
Evan


They have a different flat head on them that you won't find in any hardware stores and the like.
Nerdtendo might have some in stock. Send him a PM.
Here is his coin mech thread. http://forums.arcade-museum.com/showthread.php?t=204843
 
During my DK Jr restore I noticed that neither of the coin mech face plates were attached to the door itself and merely held there by gravity from the coin mechs themselves inside the door.

The faceplates I have are the standard 740s (round coin return button in the center) with circular holes in each of the 4 corners (as opposed to the square holes found on the 730-As and most carriage bolts).

Can someone provide a description (and possibly) a picture of what the bolts and nuts are? My guess is a 4mm (assuming Nintendo used metric on everything), but not sure what type of bolt is used.

Thanks in advance,
Evan

When I get back from the hospital and my hiatus I will be placing an order to restock my inventory. I will also be getting all the diferent mounting hardware (faceplate to cab, mech to faceplate, and microswitch mounting screws) for both models so I will have that available too even though it is not up there righ now.
 
Not in the hospital yet. Just making a trip out to Baltimore to go to Johns Hopkins to see if they can figure out what's wrong with me...fingers crossed.
 
Back
Top Bottom