Nintendo Cab T-Mold Length

Azurden

Well-known member

Donor 4 years: 2013-2016
Joined
Aug 6, 2013
Messages
2,663
Reaction score
64
Location
Fairview, Pennsylvania
Hey Guys...

Getting a Popeye Nintendo in on trade and needs T-Molding.... Two questions...

1: How much (ft) of the t-mold is needed for this cab? I would like to pre order.

2: It looks like in the picts that there is a piece of black t-mold at the bottom of the bezel area? Yes?
 
Last edited:
+1 on the Chomping Quarters stuff. It's super nice.

Word of warning if your cab is ply with the gelcoat; that stuff is super brittle at the edges. I chipped it in a couple locations while tapping the t-molding into place with a rubber mallet on my DK. Was super bummed. Gonna try a roller to install it on my Playchoice.
 
+1 on the Chomping Quarters stuff. It's super nice.

Word of warning if your cab is ply with the gelcoat; that stuff is super brittle at the edges. I chipped it in a couple locations while tapping the t-molding into place with a rubber mallet on my DK. Was super bummed. Gonna try a roller to install it on my Playchoice.

Thanks for the heads up on that....
 
Question - is the 20' enough to include the control panel? I only ask because there is a separate link if you scroll down, for "True Flat Nintendo T-molding For Control Panel".
 
Question - is the 20' enough to include the control panel? I only ask because there is a separate link if you scroll down, for "True Flat Nintendo T-molding For Control Panel".

20 feet will do a whole game. The separate link for cp molding is needed on particle board cabs, because the sides need offset, but the cp usually doesn't.
 
Back
Top Bottom