New Tube Swap K7000

[SteelRush]

So my Golden Tee 2005 had some pretty serious MK burn. I found a Zenith 25" on Craigslist and picked it up. The tube was so clean I think I could eat on it.

Turns out the tube already had all the WG style connections needed for my K7000. I fired it up and have a reversed upside down picture so I will have to change some yoke wires tomorrow. For now, here's a picture of the new tube.

 

[ieure]

When you swap the leads around, don't break the connector up! I see a bunch of monitors like this & its always a huge pain in the ass to mate up the connectors.

The pins pop right out if you use a Molex pin extractor, small screwdriver, thin metal rod etc.

 

[SteelRush]

When you swap the leads around, don't break the connector up! I see a bunch of monitors like this & its always a huge pain in the ass to mate up the connectors.

The pins pop right out if you use a Molex pin extractor, small screwdriver, thin metal rod etc.

Thanks for the tip. I did not want to break the connector and was figuring out how to not have to do that.