This joystick was never used, though it was installed in a control panel. I acquired a NOS kit that had the joysticks and wires installed. So I had to remove the solder holding the wires.
I took apart the joystick, cleaned the original dried lubricant and re-lubed it with a heavy duty grease.
One of the leafs has a very short piece of the leaf where the wires were, broken off. (Pictured)
There may be some minor rust (again pictured), from sitting installed in a control panel vs. in a plastic bag.
$100 shipped
I do need a repro AVG for my major havoc build, or make other trade offer if you like.
I took apart the joystick, cleaned the original dried lubricant and re-lubed it with a heavy duty grease.
One of the leafs has a very short piece of the leaf where the wires were, broken off. (Pictured)
There may be some minor rust (again pictured), from sitting installed in a control panel vs. in a plastic bag.
$100 shipped
I do need a repro AVG for my major havoc build, or make other trade offer if you like.
Attachments
Last edited:
