never let your shop get out of controll

discgolfer72

New member
Joined
Dec 9, 2008
Messages
1,425
Reaction score
4
Location
overland park, Kansas
ok well over the past few weeks i have begun to take back control of my shop over the years of just throwing parts into buckets and just stacking stuff on top of stuff i have had it

my shops is now pretty much back in order but i had 5 of thoes big clear storage buckets full of screws speakers and just random crap that has come from diffrent cabs i had to gut or from auction buys

i have been at it since 9 thismorning and im on my final bucket (just dumped it out)

all i can say is crap my back hurts and from now on every part i pull or buy is going to have a proper place and never am i letting my shop get that bad again lol

HPIM0423.jpg


the bad part is all thoes coin buckets are what i have been sorting nuts n bolts in and i still have to go thrue each one of thes and sort them into my parts containers i just hung on the wall
 
Last edited:
lol yea it is a pia but on the up side i have found some good stuff i didnt rember i had and filled a small bucket with tools that i have been looking for for weeks lol
 
You are satan

Someotherguy said:
To all the people that are now sweating the hassle of finding 19" monitors, you shoulda been at my place back in 2003 as I threw out FIFTY because nobody would come get them.
 
Last edited:
To all the people that are now sweating the hassle of finding 19" monitors, you shoulda been at my place back in 2003 as I threw out FIFTY because nobody would come get them.

Richard

If you had been on this site in 03 and posted "50 free monitors" you would have had about 50 pms in about 5 mins and probably a half dozen to a dozen people ready to come pick them up.
 
lol yea i would have grabbed all the monitors i need some good tubes right about now and a 25k7000 chasiis (actually i need 3 25k7000 chassis )

well whew almost done

i took all 5 buckets and now im left with a full nuts n bolts container
and 1 bucket and a coin box full of brakcets lol

HPIM0426.jpg

HPIM0424.jpg


HPIM0425.jpg


all i have left to do is put all my tools away and straighten up my solder/pcb work station
 
Hehe. Tell me about it. I've spent the last two days working in my basement. Finally have the arcade area cleared up so I can move the other machines in, but I still have a LOT of sorting ahead of me. I collect old computers as well as arcade machines, so I have many boxes of computer cables, parts, boards, disks and tapes, and various other junk to sort through. Haven't even gotten to the arcade parts yet...

-Ian
 
if I posted pics of my work's shop area, you'd all run screaming........into the pile and start grabbing stuff.....
 
Back
Top Bottom