Just replaced the flyback. G2 on the neck connector is sparking, I've tested the resistor and the esr capacitor looks good. Anyone know what might be wrong?
Note: The connector is still sparking with it disconnected from the tube so it's not the tube.
Update for anyone that might have this issue in the future... I put the flyback wires on the neck board backwards because I was following the wire colors. On the new flyback the red wire/thicker wire goes to the neck connector and the grey wire/thin wire goes to the neck board itself.
Does anyone sell the horizontal width coil for this chassis? I'm going to try adjusting mine tonight, but it looks a little grungy. Hoping it doesn't break, but just incase.