Neotech NT-25E tech help please

rickpav

Member

Donor 2012
Joined
Dec 6, 2011
Messages
54
Reaction score
11
Location
Bethlehem, Pennsylvania
I purchased a Cruis'n World with a bad monitor. I have since replaced the flyback, HOT and the cap kit from Bob Roberts. When I now power up the game I just can't get it to sink in properly. I'm about an inch to two slid too far to the right. For the most part I'm having a heck of a time trying to get it to sync in horizontally. Does anyone have any advise where I should go from here? I have never known this factory original display to work properly. In fact when I got the machine the monitor only chirped when powered up. The game did play blind. I have since connected another known good monitor and everything still appears to work properly. If I install the original problem monitor I'm right back to where it doesn't want to display properly. Lastly, if I do dial it in I can get the horizontal to stay put but the entire display is off that inch or two and it kinda looks a little wrapped around ever so slightly.
Again, any advice would be greatly appreciated.
Thanks
Rick Pav
 
Back
Top Bottom