Museum of the Game® & International Arcade Museum® Forums

Has someone taken the convergence rings off of this NT-500DX? I took this monitor out of an old cabinet I had laying around and after installing it I noticed I couldn't get the image completely focused, after putting the test pattern generator on it I found the convergence was slightly off in the center and pretty bad around the edges so I went to see if the convergence rings had slipped or something only to see this...
1000027293.jpg
So I'm not wrong am I, this monitor should definitely have convergence rings right? Or is that brown looking ring some kind of unadjustable factory set convergence.
Back
Top Bottom