Neotec nt-2515c - area 51 ?

NCC-1701

New member
Joined
Nov 19, 2010
Messages
98
Reaction score
1
Location
New Jersey
Can I replace the original NT Monitor with an WG Model Number 25K7191 Medium Resolution, my concerns are the Gun Opto's registering correctly on the Wells Gardner
 
Area 51 is a standard resolution game and will not display correctly with a medium res monitor.

What is wrong with your Neotec?
 
Last edited:
I'll try to answer both replies in this reply. My Neotech 2515 Monitor comes on okay but within a few minutes picture goes from sharp to an out of focus blur, so out of focus that the Guns don't register the shots accurately, also not able to get rid of the horizontal lines across the screen every two inches on a slight angle, based on some research on this forum seems like my flyback is probably taking a crap.

I already ordered a complete cap kit and new flyback from Arcade Shop for the 2515, toying with rebuilding the Neotech chassis or putting in the WG replacement which was only used for a few months. Seller of the WG states it's a Medium resolution but not sure if that statement is correct. Should I just rebuild what I have and go from there. Thanks for the help.
 
My Neotech in my Area 51/ Max Force suffered from the getting fuzzy issue. I did a cap kit and replaced the flyback and have no issues now. I'd recommend just repairing yours.
 
Okay, Cap Kit and Flyback it is. Great bunch of guys here, really appreciate the help.
 
I have mrcft-216 which you will use for your neotec chassis for $33.00 shipped
in stock now..

to answer you question about the k7000 yes you can cross them to the neotec 2515c tube since they unusually use the exact same yoke.
 
Back
Top Bottom