Neotec nt-2502 cap kit install

bold69

Active member
Joined
Jul 7, 2012
Messages
1,205
Reaction score
8
Location
Elk Grove, California
I just pull the chassis out on my other California Speed that has Neotec NT-2502.
It seems one side of the cap is loose and upon further inspection it's because there is no longer a solder point on the board seems the solder point has burnt off.

My question is how do I replace that cap now if there is no place to solder to?
The trace does lead to other points do I just bridge a wire to one of them?

Any tips would be great.

Thanks,
Ed
 
Yep either scratch off some of the protective coating above the trace and solder to it. Or get some wire and create a jumper to the next solder point in line of that trace. Depends on you soldering skill and confidence.
 
Back
Top Bottom