Need to know what tool to use on revolver vs or play choice gun

needhelp

Active member

Donor 3 years: 2016, 2021, 2024
Joined
Jul 8, 2009
Messages
1,018
Reaction score
7
Location
Indianapolis, Indiana
Need to know what tool to use on revolver vs or play choice gun

I have a red revolver from a vs or play choice game. I just need to know what tool to use to unscrew the screws to take apart. Or where can I get the tool to take it apart.

Thanks
 
Isn't it just a Torx-20? Or maybe -15?

get that 100-piece set from Harbor Freight for $8 and it should have the piece you need. if I knew where my gun was, I'd check for you to see which size it was...
 
Make sure to get a bit with a long skinny shaft (lol) because the thicker ones wont fit in the deeper slots (lol)

....Thats what she said
 
Thanks for all the reply

I am going to goto harbor freight now and see if I can find the 100 piece set that modessitt Mentioned. Thank you all for the replies. If I can find at harbor freight I will buy the tool on ebay.


Thanks
 
I am going to goto harbor freight now and see if I can find the 100 piece set that modessitt Mentioned. Thank you all for the replies. If I can find at harbor freight I will buy the tool on ebay.


Thanks


By the why guys they are not in that 100 piece set at harbor frieght..I ended up buying the tools on ebay. Nice try Modessitt..That is for the people looking for the tool too..


thanks for all the replys though
 
Last edited:
It is the 4.5mm security bit as mentioned above, just be sure to get a "deep" version, not the standard short bit.

The original tool was made by OSG Corporation which is who made the Nintendo screws.
OSG tool # DLH3-95 = 4.5mm screws
OSG tool # DLH2-95 = 3.5mm screws

Same tools used for Nintendo game cartridges and such.

I prefer the screwdriver style versus the "bits".
 

Attachments

  • DLH3-95 a.jpg
    DLH3-95 a.jpg
    94.6 KB · Views: 7
  • DLH3-95 b.jpg
    DLH3-95 b.jpg
    39.7 KB · Views: 5
Back
Top Bottom