Need some help finishing up MCR repro harnesses

Level99

Permanently Banned - Anon seller failed to verify

Donor 2016-2017
Joined
Apr 1, 2016
Messages
235
Reaction score
3
Location
California
If you've seen my harness work before, you know that I pay attention to the details. As such, I've been at a stumbling block with the release of my MCR harnesses due to lack of available information.

Specifically with the various control panel harnesses and the power harnesses. Can someone provide me with detailed photo's of the power harness for Tron, Timber, Tapper and Spy Hunter? I also need the same for the backside of the control panels of Timber, Tapper, Spy Hunter, Domino Man and Kickman. In these pictures, I need to see the wires going into each connector from as many angles as possible.

I should have some original harnesses on the way to me right now, but I cannot yet confirm that they are in fact actually on the way. I've held off on this project far too long. I'd like to get this completed and offer quality reproduction MCR harnesses ASAFP. Any help?
 
Back
Top Bottom