Need help with WeiYa Chassis on Hantarex MT-9000

kjeffery

New member
Joined
Nov 15, 2009
Messages
4,502
Reaction score
49
Location
Walcott, Iowa
I just installed my new universal WeiYa 14-20 inch chassis on my Hantarex MT-9000 19inch and the picture looks good but the H-width is to big and I adjusted the width coil and it still doesn't go small enough, the v-position doesn't go up for enough either leaving about a half 3/4 inch back bar on top, any ideas?
 
Many "universal" type replacement chassis have a (N)arrower - (W)ider jumper wire on the chassis. This sets the range of the width circuit.
 
Back
Top Bottom